Aegis AEGIS 1000 El manual del propietario descargar pdf (Pagina 16)

Trouble Indications

The Aegis 1000 constantly monitors the alarm zones and several internal matters and will alert you if it detects trouble. The

particular trouble is indicated on the bottom line of the display and a trouble signal is given by beeping the console beeper

continuously, 2 beeps per second.

When any trouble condition occurs, the console will beep twice per second and continue to beep until the ' * ' key (cancel) is

pressed to acknowledge the trouble. The console will say "TRBL NOW" (trouble now) if the trouble condition actually exists

while you are looking at the console. It will say "HAD TRBL" (had trouble) if the trouble occurred and then corrected itself.

The following are trouble indications and their meanings:

Ø ZONE NAME TRBL NOW or HAD TRBL: If the reading for a zone becomes abnormal, trouble will be indicated on that

-See Status \ . Excessive resistance in the contact and wiring usually causes trouble on security zones. If the cause

is not obvious, call your installer for service.

Ø AC POWER OFF TRBL NOW or HAD TRBL: Indicated if the normal house current powering the Aegis 1000 controller

that it hasn't come out of the wall socket; check to see that the socket has power; check the MAIN fuse (F3) on the Aegis

BATTERY LOW TRBL NOW or HAD TRBL:

battery voltage is too low, then the console will indicate "BATTERY LOW". If this happens, make sure that the battery is

Status | Test command is given.

Ø COMMUNICATOR TRBL NOW or HAD TRBL: Indicated if the digital communicator (not the voice dialer) was unable

with the system, central station, or the phone line. Call your installer for service.

Ø FUSE TRBL NOW or HAD TRBL: Indicated when the solid state fuse that protects the Auxiliary power supply opens.

Ø Indicated if the phone line is dead for more than 1 minute.

To silence the trouble beeps on the console, press the ' * ' key. If more than one type of trouble has occurred, the display will

show each one for two s

- Set Up Arming, Beep On Trouble

disable the beeper.

Ø Indicated in the event that the console's alarm functions are no longer operational. This may

. All Aegis 1000 codes are 4 digits in length. A code can be any

number from 0001 to 9999. Each user should be assigned a security code with an authority level and times in which the code will

o doesn't need to know them.

The levels of authority that you can assign to a user code are Master, Manager, and User.

Master Code

The Master code allows complete access to the entire system. Only the owner(s) or the one(s) who will govern the system should

- Set Up Codes.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 72 73

Sin comentarios

Aegis AEGIS 1000 El manual del propietario Pagina 16