Aegis AEGIS 1000 Manual de instalación descargar pdf (Pagina 14)

Page

LCD CONSOLE HOOKUP

1. 4 LCD Consoles (Models 11A00- -6, 7, and -

Use 4 conductor 22- be

divided by the total number of consoles at the end of the run. For example, for 4 consoles, the maximum length reduces to

The console should be m

reach of young children. A good height is approximately 58 inches from the floor to the bottom of the console enclosure.

4. late (slots on bottom of console will release back plate, use a screwdriver). Mount the back

plate to the wall. Mounting holes are designed to fit on a single or double gang box, or directly to the wall. Pull the wires

in the back plate. Splice the wires to the supplied cable. Connect the cable to the

connector on the console board (J1). Snap the console face on to the back plate. Remove protective film from the LCD lens.

5. Refer to FIGURE 6 (CONSOLE CONNECTIONS) this configuration.

CONSOLE SETUP

The console has different operating options that can be setup from the console to the user's preference. If more than one console

hange the address of a console through the

console setup mode.

To enter the console setup mode, simultaneously press and hold the 4 and up arrow (ñ) for approximately 1 second. The console

setting. The bottom line will show a menu of your options. To the lower right c

Where possible, the up (↑), down (↓), and two-headed arrow characters are shown on the console display to indicate which arrow

keys may be pressed at that time. Press the down arrow (ò) key to advance to the next item. Press the up arrow (ñ) key to go

back to the previous item.

CONSOLE ADDRESS

If you are installing more than one console, each console must be set to a different address. The default address setting is (1) -

this is adequate if only one console is being used. The choices at the bottom are 1-16; however, the Aegis 1000 only supports 4

consoles. When making your choice, choose an address between 1-4, then press the # (pound) key.

SOUNDER

If you wish not to hear the beeper in the console for any reason, the sounder option can be turned off. Select (0) for OFF or (1)

for ON, then press the # key.

KEY CLICK

The sounder makes a click every time a key is pressed. This option may also be turned off. Select (0) for OFF or (1) for ON,

then press the # key.

KEY BACKLIGHT

The keys on the console keypad are lit. The keys can be never lit, always lit, or only lit when the LCD display is lit. Select (0)

OFF, (1) for ON, or (2) TIMED, then press the # key.

VIEWING ADJUSTMENT

This option is an adjustment for the viewing angle of the LCD display. This has been set to its best value at the factory, however,

you may wish to adjust it. The display has 20 levels of adjustment. Select (1) for a lower viewing angle, or (2) for a higher

viewing angle.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 49 50

Sin comentarios

Aegis AEGIS 1000 Manual de instalación Pagina 14